Monday, April 2, 2012

The proper way to water your lawn

When you understand your lawn's environmental needs and tailor your lawn care practices to suit local conditions, you get a healthy, environmentally friendly lawn. Design your yard so it thrives on rainwater alone, without additional irrigation. Have you checked your rain sensor lately? Does your automatic lawn sprinkler system even have a rain sensor? Since 1991 there has been a mandatory law here in Florida that states that all automatic lawn sprinkler systems installed after that date must have a rain sensor device installed.

Tips to Get You Started

Mulch your garden and landscape beds.

Mulch helps keep the soil moist and reduces erosion and weeds. Avoid piling mulch against plant stems and tree trunks to prevent rot. For more info, go to our Web page on Mulches. Unsure how much mulch is needed? Check here to find out.
Image courtesy of St. John's River Water Management District

Water at the right time.

Watering in the early morning or late evening when temperatures and wind speeds are the lowest will reduce water loss through evaporation.  Tighter watering restrictions may be in order for different counties ranging from one day per week to two days per week and as restrictive as from 8:00 am to 6:00 pm for no watering.

Set your timers.

To keep your yard healthy with just enough water, it is important to set your timer with a watering schedule that suits your area considering the amount of rainfall you usually get. For example, in central Florida, a suggested watering schedule is two days a week (such as Monday and Thursday) with an irrigation run time that varies by month, as described in the table below.
January--12 minutesJuly--49 minutes
February--10 minutesAugust--60 minutes
March--17 minutesSeptember--48 minutes
April--40 minutesOctober--43 minutes
May--64 minutesNovember--32 minutes
June--50 minutesDecember--16 minutes
By following a similar type of schedule in your area, you can save about 10 - 20% on your water bill. However, keep a close eye for signs of excessive wilting if rainfall is not typical. The amount of watering needed can vary by the types of plants you have in your yard. Planting native plants can also help conserve water in your landscape.

Calibrate your irrigation system.

Be sure to calibrate your irrigation system to determine how long to run the system so that it delivers the amount of water recommended for your area. Irrigation systems can be very different and could be delivering too much, not enough, or just the right amount of water, depending on the type of irrigation system and the zone being watered.

Position sprinklers properly.

Make sure the water lands on your plants and grass and not on paved areas.
tuna canLawns only need about ¾ inch of water in one watering session. Place empty tuna cans or measuring cups around the yard (all within range of the sprinkler, some close, some farther away). Turn on the sprinkler for 30 minutes. After 30 minutes, measure the amount of water collected in each can/cup. Check to see if there was even distribution of water in all the cans/cups. If the cans/cups collected ¾ inch of water, then you know you need to water for 30 minutes. If the cans/cups collected more or less than ¾ inch of water, then calculate approximately how long you need to water your landscape so that it receives ¾ inch of water in each watering session.

Use micro-irrigation hoses.

These hoses can lie above ground or slightly buried and allow for water to seep through to a plant's roots.

Make the most out of rainwater.

Turn downspouts from rain gutters towards areas with planting. Rainwater can also be collected and stored in a rain barrel for dry spells.

Til next week  Lee & Veronica

No comments:

Post a Comment